IBIS
DESIGN FEATURES
- Hull draft 6” with 150 Yamaha and fuel
- Custom built, one boat at a time
- Ultra shallow hole shot and draft on plane
- Super dry, stable hull
- Original design developed on the water
- Easy poling
- Low profile, not as affected by the wind
- Lamiflowtm chine and submerged lift strakes for quiet poling
- Recessed transom
- NewWaters exclusive Lamiflowtm tunnel design, providing sufficient water flow to allow the propeller to be run above the hull bottom in an energy-efficient laminar flow of water, permitting the ultimate in shallow water performance without damaging
- our precious sea grass
- Smooth riding, seakindly hull
- Self-bailing, cambered deck surfaces - nothing drains into bilge
- High quality Class-A fit, finish, and construction
- Large cavernous dry storage compartment, guttered, gasketed and quiet, with locking stainless steel latch and gas-assist lift
- Tub-guttered, gasketed and insulated aft dry storage - can be plumbed for livewell (optional)
- Horizontal rod storage locker - will accomodate 6 rods up to 9' plus, with two outer compartments large enough for spin rods
- Molded diamond nonskid - very efficient and easy cleaning
- Anchor tub - molded inn
- Six-person U.S. Coast Guard rated
- Two 90-quart Igloo coolers with upholstery
- Clean, non-glare, custom blended NewWater white hull
- All deck hardware recessed for a snag-free surface.
- Teleflextm high-performance, no feedback steering.
- 47 gallon .125 tig welded aluminum fuel tank
- Two bilge pumps / manual & auto float switch
- Fish measuring device molded into hatch
- Full 5-year structural limited warranty
HARDWARE
- All anodized aluminum or 316 stainless steel hardware thru bolted, with nylon lock nuts
- “6 stainless pop-up cleat on foredeck
- Two stainless steel flush ties midship
- Stainless steel fuel fill and vent
- Welded anodized aluminum console grab rails
- Flush double pin stainless steel hinges
- Stainless steel bow and stern eyes
- PVC and stainless steel rub rail-through bolted
- Two pair TLC anodized aluminum cooler chocks
HELM
- Ergonomically designed center helm
- Weather protected, recessed, backlit switches and 12 volt power supply with circuit breakers
- Color-coded tinned copper wiring harness
- Welded anodized aluminum grab rails
- Hinged/lift-out locking door with removable storage pouch
- Anodized aluminum steering wheel
- Fiberglass fastened to deck prior to hand-finishing
CONSTRUCTION
- Divinicelltm PVC foam core construction
- Modified epoxy resin
- Cooktm Amorcote in mold coating
- Total wood-free composite
- All parts 100% hand laid
- Extensive fiberglass stringer grid with limbers to ensure complete inner hull drainage.
- Totally unsinkable, with closed cell foam flotation kept outboard and high to prevent water absorption.
See Ibis Slideshow