 |
 |
 |
 |
| Curlew Info | Ibis Info | Avocet Info | Testimonials | NewWater Guides | About Us | Contact Us | Home |
|||
Announcements and Upcoming Events
| View Our Slide Show! All New! |
|
|
| Upcoming Events 3rd NewWater Owners Tournament, Rockport––August 1-2, 2008 2nd NewWater Owners Tournament, Rockport, June 8-9, 2007 Check the results! |
LAMIVENT TM
Patent Pending NewWater Boatworks is pleased to introduce its new LAMIVENT TM. This technology will soon be available in all NewWater boats. The tunnel design on NewWater boats is the most efficient on the market, but as with all tunnels, they still create a certain amount of drag and resistance. Our new technology basically gives the shallow draft performance NewWater owners have all come to know yet also provides the ability to empty the tunnel, lower the engine, decrease the resistance and increase the speed on command. With this innovation, speed increases 8 to 12 percent on the Ibis, and is expected to be even greater on the Curlew and Avocet. These figures are conservative, in that very little has been done on propellers best suited to the tunnel/non-tunnel application. No data has been gathered regarding fuel savings, but it is estimated that it will be even greater than speed gains. When you experience this new innovation, you will be astonished at the way you can be running along, lower the engine on the jack, push a button, rpm increases by 1000, speed increases, trim angle changes and ride quality improves. When needing to go shallow, simply with the push of a button, the tunnel goes laminar, and up goes the engine. |
|
Ibis Update
Many of you may have heard about our Ibis "hull marriage." (A marriage,
as it is referred to in the industry, is when a part built in a mold
refuses to demold after cure.) While it often times is commonplace to
refinish a mold after such an ordeal, we refused to compromise our fit
and finish in this manner. Since we were forced to redevelop a master
pattern and construct a new hull mold, we felt it an opportunity to
implement new technologies into the Ibis running surface learned
through a development of another model we are creating. These new
technologies will enhance dynamic plane performance. The New Generation Ibis II will be completed soon.
|
|
Recent Design Enhancements
*We
have devised a way to incorporate molded backsides on our hatches
on all of our 2008 models without added weight. *We have re-engineered the drain system on our rod lockers to do an even better job than before. *Check out the most exciting development in fly line management -- NewWater's Line Minder |
| Home |
 |
Physical
Address: 13406 Donop Road Elmendorf, TX 78112 Mailing Address: P.O. Box 35494 San Antonio, Texas 78235-0494 Phone: (210) 648-2206 FAX (210) 648-5306 |
Our Boats are sold FACTORY DIRECT, and custom rigged with your choice of outboard.
 |
If you need top quality accessories for your boat, visit our sister site Pro-Line Custom Aluminum. Texas' Oldest Marine Fabricator (since 1983) |
 |